FreeBSD Manual Pages
AHD(4) FreeBSD Kernel Interfaces Manual AHD(4) NAME ahd -- Adaptec PCI/PCI-X Ultra320 SCSI host adapter driver SYNOPSIS For one or more PCI/PCI-X cards: device pci device ahd To compile in debugging code. options AHD_DEBUG options AHD_DEBUG_OPTS=<bitmask of options> options AHD_REG_PRETTY_PRINT To configure one or more controllers to assume the target role: options AHD_TMODE_ENABLE=<bitmask of units> For one or more SCSI busses: device scbus DESCRIPTION This driver provides access to the SCSI bus(es) connected to Adaptec AIC7901 and AIC7902 host adapter chips. These chips are found on many motherboards as well as the 29320 and 39320 Adaptec SCSI controller cards. Driver features include support for narrow and wide busses, fast, ultra, ultra2, ultra160, and ultra320 synchronous transfers, packetized trans- fers, tagged queueing, 512 SCB's, and target mode. The ``AHD_DEBUG_OPTS'' option is used to control which diagnostic mes- sages are printed to the console when ``AHD_DEBUG'' is enabled. Logi- cally 'or' the following bits together: Value Function 0x0001 Show miscellanious information 0x0002 Show sense data 0x0004 Show Serial EEPROM contents 0x0008 Show bus termination settings 0x0010 Show host memory usage 0x0020 Show SCSI protocol messages 0x0040 Show mode pointer of the chip register window 0x0080 Show selection timeouts 0x0100 Show FIFO usage messages 0x0200 Show Queue Full status 0x0400 Show SCB queue status 0x0800 Show inbound packet information 0x1000 Show S/G list information 0x2000 Enable extra diagnostic code in the firmware The ``AHD_REG_PRETTY_PRINT'' option compiles in support for human-read- able bit definitions for each register that is printed by the debugging code. However, it also bloats the compiled size of the driver by approx- imately 215KB. Individual controllers may be configured to operate in the target role through the ``AHD_TMODE_ENABLE'' configuration option. The value assigned to this option should be a bitmap of all units where target mode is desired. For example, a value of 0x25, would enable target mode on units 0, 2, and 5. Note that target mode is only supoprted for ultra160 speeds and below. Per target configuration performed in the SCSI-Select menu, accessible at boot, is honored by this driver. This includes synchronous/asynchronous transfers, maximum synchronous negotiation rate, wide transfers, discon- nection, and the host adapter's SCSI ID. BUGS The current generation of 79xx chips do not support target mode in Ultra320 mode. Target mode in general has not been well tested in this driver. SEE ALSO ahc(4), cd(4), da(4), sa(4), scsi(4) AUTHORS The ahd driver, the AIC7xxx sequencer-code assembler, and the firmware running on the aic79xx chips was written by Justin T. Gibbs. This manual page is based on the ahc(4) manual page. HISTORY The ahd driver first appeared in FreeBSD 4.7. FreeBSD 11.1 September 1, 2002 FreeBSD 11.1
NAME | SYNOPSIS | DESCRIPTION | BUGS | SEE ALSO | AUTHORS | HISTORY
Want to link to this manual page? Use this URL:
<https://www.freebsd.org/cgi/man.cgi?query=ahd&sektion=4&manpath=FreeBSD+4.8-RELEASE>