FreeBSD Manual Pages
NCV(4) FreeBSD Kernel Interfaces Manual NCV(4) NAME ncv -- NCR 53C500 based SCSI host adapter driver SYNOPSIS To compile this driver into the kernel, place the following lines in your kernel configuration file: device scbus device ncv Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5): ncv_load="YES" DESCRIPTION The ncv driver provides access to the SCSI bus connected to an NCR 53C500 based PC-Card SCSI host adapter or an Adaptec AHA-2920 on the PCI bus. HARDWARE The following devices are currently supported by the ncv driver: +o I-O DATA PCSC-DV +o KME KXLC002 (TAXAN ICD-400PN, etc.), KXLC004, and UJDCD450 +o Macnica Miracle SCSI-II mPS110 +o Media Intelligent MSC-110, MSC-200 +o NEC PC-9801N-J03R +o New Media Corporation BASICS SCSI +o Qlogic Fast SCSI +o RATOC REX-9530, REX-5572 (SCSI only) DIAGNOSTICS The following error messages are sometimes returned: SCSI BUS RESET failed Usually returned when a failure occurs during the bus reset. CMD_NOP failed No operation or the operation has failed. CMD_NOP|CMD_DMA A failure occurred during the DMA read/write operations. The ncv driver should return [ENODEV] when any of the previously noted failures occur. SEE ALSO cardbus(4), cd(4), da(4), pccard(4), sa(4), scsi(4) HISTORY The ncv device driver has been developed for NetBSD/pc98 and ported to FreeBSD. The ncv driver first appeared in FreeBSD 2.2 with PAO and merged in FreeBSD 4.2. AUTHORS The ncv driver was written by Naofumi Honda. This manual page was writ- ten by Tom Rhodes <trhodes@FreeBSD.org> and Noriaki Mitsunaga <non@FreeBSD.org>. FreeBSD 6.2 August 10, 2004 FreeBSD 6.2
NAME | SYNOPSIS | DESCRIPTION | HARDWARE | DIAGNOSTICS | SEE ALSO | HISTORY | AUTHORS
Want to link to this manual page? Use this URL:
<https://www.freebsd.org/cgi/man.cgi?query=ncv&sektion=4&manpath=FreeBSD+6.2-RELEASE>