FreeBSD Manual Pages
RADEON(4x) RADEON(4x) NAME radeon - ATI/AMD RADEON video driver SYNOPSIS Section "Device" Identifier "devname" Driver "radeon" ... EndSection DESCRIPTION radeon is an Xorg driver for ATI/AMD RADEON-based video cards with the following features: o Full support for 8-, 15-, 16- and 24-bit pixel depths; o RandR 1.2 and RandR 1.3 support; o Full EXA 2D acceleration; o Textured XVideo acceleration including anti-tearing support (Bicubic filtering only available on R/RV3xx, R/RV/RS4xx, R/RV5xx, and RS6xx/RS740); o 3D acceleration; SUPPORTED HARDWARE The radeon driver supports PCI, AGP, and PCIe video cards based on the following ATI/AMD chips (note: list is non-exhaustive): R100 Radeon 7200 RV100 Radeon 7000(VE), M6, RN50/ES1000 RS100 Radeon IGP320(M) RV200 Radeon 7500, M7, FireGL 7800 RS200 Radeon IGP330(M)/IGP340(M) RS250 Radeon Mobility 7000 IGP R200 Radeon 8500, 9100, FireGL 8800/8700 RV250 Radeon 9000PRO/9000, M9 RV280 Radeon 9200PRO/9200/9200SE/9250, M9+ RS300 Radeon 9100 IGP RS350 Radeon 9200 IGP RS400/RS480 Radeon XPRESS 200(M)/1100 IGP R300 Radeon 9700PRO/9700/9500PRO/9500/9600TX, FireGL X1/Z1 R350 Radeon 9800PRO/9800SE/9800, FireGL X2 R360 Radeon 9800XT RV350 Radeon 9600PRO/9600SE/9600/9550, M10/M11, FireGL T2 RV360 Radeon 9600XT RV370 Radeon X300, M22 RV380 Radeon X600, M24 RV410 Radeon X700, M26 PCIe R420 Radeon X800 AGP R423/R430 Radeon X800, M28 PCIe R480/R481 Radeon X850 PCIe/AGP RV505/RV515/RV516/RV550 Radeon X1300/X1400/X1500/X1550/X2300 R520 Radeon X1800 RV530/RV560 Radeon X1600/X1650/X1700 RV570/R580 Radeon X1900/X1950 RS600/RS690/RS740 Radeon X1200/X1250/X2100 R600 Radeon HD 2900 RV610/RV630 Radeon HD 2400/2600/2700/4200/4225/4250 RV620/RV635 Radeon HD 3410/3430/3450/3470/3650/3670 RV670 Radeon HD 3690/3850/3870 RS780/RS880 Radeon HD 3100/3200/3300/4100/4200/4250/4290 RV710/RV730 Radeon HD 4330/4350/4550/4650/4670/5145/5165/530v/545v/560v/565v RV740/RV770/RV790 Radeon HD 4770/4730/4830/4850/4860/4870/4890 CEDAR Radeon HD 5430/5450/6330/6350/6370 REDWOOD Radeon HD 5550/5570/5650/5670/5730/5750/5770/6530/6550/6570 JUNIPER Radeon HD 5750/5770/5830/5850/5870/6750/6770/6830/6850/6870 CYPRESS Radeon HD 5830/5850/5870 HEMLOCK Radeon HD 5970 PALM Radeon HD 6310/6250 SUMO/SUMO2 Radeon HD 6370/6380/6410/6480/6520/6530/6550/6620 BARTS Radeon HD 6790/6850/6870/6950/6970/6990 TURKS Radeon HD 6570/6630/6650/6670/6730/6750/6770 CAICOS Radeon HD 6430/6450/6470/6490 CAYMAN Radeon HD 6950/6970/6990 ARUBA Radeon HD 7000 series TAHITI Radeon HD 7900 series PITCAIRN Radeon HD 7800 series VERDE Radeon HD 7700 series OLAND Radeon HD 8000 series HAINAN Radeon HD 8000 series BONAIRE Radeon HD 7790 series KAVERI KAVERI APUs KABINI KABINI APUs HAWAII Radeon R9 series MULLINS MULLINS APUs CONFIGURATION DETAILS Please refer to xorg.conf(5) for general configuration details. This section only covers configuration details specific to this driver. The following driver Options are supported: Option "SWcursor" "boolean" Selects software cursor. The default is off. Option "Accel" "boolean" Enables or disables all hardware acceleration. The default is on. Option "ZaphodHeads" "string" Specify the RandR output(s) to use with zaphod mode for a par- ticular driver instance. If you use this option you must use this option for all instances of the driver. For example: Option "ZaphodHeads" "LVDS,VGA-0" will assign xrandr outputs LVDS and VGA-0 to this instance of the driver. Option "ColorTiling" "boolean" The framebuffer can be addressed either in linear or tiled mode. Tiled mode can provide significant performance benefits with 3D applications. Tiling will be disabled if the drm module is too old or if the current display configuration does not support it. On R600+ this enables 1D tiling mode. The default value is on for R/RV3XX, R/RV4XX, R/RV5XX, RS6XX, RS740, R/RV6XX, R/RV7XX, RS780, RS880, EVERGREEN, CAYMAN, ARUBA, Southern Islands, and Sea Islands and off for R/RV/RS1XX, R/RV/RS2XX, RS3XX, and RS690/RS780/RS880 when fast fb feature is enabled. Option "ColorTiling2D" "boolean" The framebuffer can be addressed either in linear, 1D, or 2D tiled modes. 2D tiled mode can provide significant performance benefits over 1D tiling with 3D applications. Tiling will be disabled if the drm module is too old or if the current display configuration does not support it. KMS ColorTiling2D is only supported on R600 and newer chips and requires Mesa 9.0 or newer for R6xx-ARUBA, Mesa 9.2 or newer for Southern Islands, and Mesa 10.1 or newer for Sea Islands. The default value is on for R/RV6XX, R/RV7XX, RS780, RS880, EVERGREEN, CAYMAN, ARUBA, Southern Islands, and Sea Islands. Option "EnablePageFlip" "boolean" Enable DRI2 page flipping. The default is on. Pageflipping is supported on all radeon hardware. Option "AccelMethod" "string" Chooses between available acceleration architectures. Valid values are EXA (for pre-TAHITI GPUs) and glamor (for R300 or higher). The default is glamor as of TAHITI, otherwise EXA. The following driver Options are supported for EXA : Option "EXAVSync" "boolean" This option attempts to avoid tearing by stalling the engine until the display controller has passed the destination region. It reduces tearing at the cost of performance and has been known to cause instability on some chips. The default is off. Option "EXAPixmaps" "boolean" Under KMS, to avoid thrashing pixmaps in/out of VRAM on low mem- ory cards, we use a heuristic based on VRAM amount to determine whether to allow EXA to use VRAM for non-essential pixmaps. This option allows us to override the heuristic. The default is on with > 32MB VRAM, off with < 32MB or when fast fb feature is enabled for RS690/RS780/RS880. Option "SwapbuffersWait" "boolean" This option controls the behavior of glXSwapBuffers and glXCopy- SubBufferMESA calls by GL applications. If enabled, the calls will avoid tearing by making sure the display scanline is out- side of the area to be copied before the copy occurs. If dis- abled, no scanline synchronization is performed, meaning tearing will likely occur. Note that when enabled, this option can adversely affect the framerate of applications that render frames at less than refresh rate. The default value is on. TEXTURED VIDEO ATTRIBUTES The driver supports the following X11 Xv attributes for Textured Video. You can use the "xvattr" tool to query/set those attributes at runtime. XV_VSYNC XV_VSYNC is used to control whether textured adapter synchro- nizes the screen update to the monitor vertical refresh to elim- inate tearing. It has two values: 'off'(0) and 'on'(1). The default is 'on'(1). XV_CRTC XV_CRTC is used to control which display controller (crtc) the textured adapter synchronizes the screen update with when XV_VSYNC is enabled. The default, 'auto'(-1), will sync to the display controller that more of the video is on; when this is ambiguous, the display controller associated with the RandR pri- mary output is preferred. This attribute is useful for things like clone mode where the user can best decide which display should be synced. The default is 'auto'(-1). XV_BICUBIC XV_BICUBIC is used to control whether textured adapter should apply a bicubic filter to smooth the output. It has three val- ues: 'off'(0), 'on'(1) and 'auto'(2). 'off' means never apply the filter, 'on' means always apply the filter and 'auto' means apply the filter only if the X and Y sizes are scaled to more than double to avoid blurred output. Bicubic filtering is not currently compatible with other Xv attributes like hue, con- trast, and brightness, and must be disabled to use those attributes. The default is 'off'(0). SEE ALSO Xorg(1), xorg.conf(5), Xserver(1), X(7) 1. Wiki page: http://www.x.org/wiki/radeon 2. Overview about radeon development code: http://cgit.freedesktop.org/xorg/driver/xf86-video-ati/ 3. Mailing list: http://lists.x.org/mailman/listinfo/xorg-driver-ati 4. IRC channel: #radeon on irc.freenode.net 5. Query the bugtracker for radeon bugs: https://bugs.freedesktop.org/query.cgi?product=xorg&compo- nent=Driver/Radeon 6. Submit bugs & patches: https://bugs.freedesktop.org/enter_bug.cgi?product=xorg&compo- nent=Driver/Radeon AUTHORS Authors include: Rickard E. (Rik) Faith faith@precisioninsight.com Kevin E. Martin kem@freedesktop.org Alan Hourihane alanh@fairlite.demon.co.uk Marc Aurele La France tsi@xfree86.org Benjamin Herrenschmidt benh@kernel.crashing.org Michel Danzer michel@daenzer.net Alex Deucher alexdeucher@gmail.com Bogdan D. bogdand@users.sourceforge.net Eric Anholt eric@anholt.net X Version 11 xf86-video-ati 7.5.0 RADEON(4x)
NAME | SYNOPSIS | DESCRIPTION | SUPPORTED HARDWARE | CONFIGURATION DETAILS | TEXTURED VIDEO ATTRIBUTES | SEE ALSO | AUTHORS
Want to link to this manual page? Use this URL:
<https://www.freebsd.org/cgi/man.cgi?query=radeon&sektion=4&manpath=FreeBSD+11.0-RELEASE+and+Ports>