FreeBSD Manual Pages
SIIS(4) FreeBSD Kernel Interfaces Manual SIIS(4) NAME siis -- SiliconImage Serial ATA Host Controller driver SYNOPSIS To compile this driver into the kernel, place the following lines in your kernel configuration file: device pci device scbus device siis Alternatively, to load the driver as a module at boot time, place the following line in loader.conf(5): siis_load="YES" The following tunables are settable from the loader: hint.siis.X.msi controls Message Signaled Interrupts (MSI) usage by the specified con- troller. hint.siisch.X.pm_level controls SATA interface Power Management for specified channel, allowing some power to be saved at the cost of additional command latency. Possi- ble values: 0 interface Power Management is disabled (default); 1 device is allowed to initiate PM state change, host is pas- sive. Note that interface Power Management is not compatible with device pres- ence detection. You will have to reset bus manually on device hot-plug. hint.siisch.X.sata_rev setting to nonzero value limits maximum SATA revision (speed). Values 1, 2 and 3 are respectively 1.5, 3 and 6Gbps. DESCRIPTION This driver provides the CAM subsystem native access to the SATA ports of controller. Each SATA port is represented to CAM as a separate bus with 16 targets. Most of the bus-management details are handled by the SATA- specific transport of CAM. Connected ATA disks are handled by the ATA protocol disk peripheral driver ada(4). ATAPI devices are handled by the SCSI protocol peripheral drivers cd(4), da(4), sa(4), etc. Driver features include support for Serial ATA and ATAPI devices, Port Multipliers (including FIS-based switching), hardware command queues (31 command per port), Native Command Queuing, SATA interface Power Manage- ment, device hot-plug and Message Signaled Interrupts. Same hardware is also supported by atasiliconimage driver from ata(4) subsystem. If both drivers are loaded at the same time, this one will be given precedence as the more functional of the two. HARDWARE The siis driver supports following controllers: +o SiI3124 +o SiI3132 +o SiI3531 SEE ALSO ada(4), cd(4), da(4), sa(4), scsi(4), ata(4) HISTORY The siis driver first appeared in FreeBSD 8.0. AUTHORS Alexander Motin <mav@FreeBSD.org>. FreeBSD 11.1 July 18, 2009 FreeBSD 11.1
NAME | SYNOPSIS | DESCRIPTION | HARDWARE | SEE ALSO | HISTORY | AUTHORS
Want to link to this manual page? Use this URL:
<https://www.freebsd.org/cgi/man.cgi?query=siis&sektion=4&manpath=FreeBSD+8.0-RELEASE>