FreeBSD Manual Pages
VPO(4) FreeBSD Kernel Interfaces Manual VPO(4) NAME vpo -- parallel to SCSI interface driver SYNOPSIS device vpo For one or more SCSI busses: device scbus0 at vpo0 DESCRIPTION The primary purpose of the vpo driver is to provide access to the Adaptec AIC-7110 SCSI controller built in the Iomega ZIP drive. But it should also work with the Iomega Jaz Traveller parallel to SCSI interface. The driver has been extended to the ZIP+ drive which is based on the Iomega Matchmaker Parallel to SCSI interface. USAGE The driver should let you use a printer connected to the drive while transfering data. DOS and FreeBSD filesystems are supported. When mounting a DOS filesys- tem or formating a FreeBSD filesystem, check the slice of the disk with the fdisk(8) utility. In order to unixify a ZIP disk, put the following in /etc/disktab: zip|zip 100:\ :ty=removable:se#512:nc#96:nt#64:ns#32:\ :pa#196608:oa#0:ba#4096:fa#512:\ :pb#196608:ob#0:bb#4096:fb#512:\ :pc#196608:oc#0:bc#4096:fc#512: and use disklabel(8). If you have trouble with your driver, your parallel chipset may not run properly at the detected mode (NIBBLE, PS2 or EPP). Tune the ppc(4) boot- flags to force other modes. SEE ALSO da(4), lpt(4), ppbus(4), ppc(4), scsi(4) BUGS During boot, the driver first tries to detect a classic ZIP, then a ZIP+. The ZIP+ detection is intrusive and may send errorneous charaters to your printer if the drive is not connected to your parallel port. HISTORY The vpo manual page first appeared in FreeBSD 3.0. AUTHORS This manual page was written by Nicolas Souchu. FreeBSD 4.10 March 5, 1998 FreeBSD 4.10
NAME | SYNOPSIS | DESCRIPTION | USAGE | SEE ALSO | BUGS | HISTORY | AUTHORS
Want to link to this manual page? Use this URL:
<https://www.freebsd.org/cgi/man.cgi?query=vpo&sektion=4&manpath=FreeBSD+4.10-RELEASE>